Video projection system will offer the best way to improve your home theater or the provision of computers for the public presentation. The lamps used in this system last about 1,000 hours. Projector bulbs need to be replaced for a false start, you lose the brightness and sharpness of the colors too. To replace it, can cost up to several hundred dollars. With a few simple steps can prevent early failure and extend the life of your projector lamp.
'SFirst, you can follow the true shut-down procedures. Lamps to produce the extreme temperatures during extended operation. Suddenly cut off all power to the projector, the lamp can be extremely without adequate ventilation. Projector scheduled following a routine especially when you press the power button, allow the fan to continue operating until the lamp has cooled. Then turn off the projector using the power cord or turn off the power stripThe device is not connected to bypass the power-down sequence.
The second step is that you think should never touch the bulb with your fingers. The oils from your skin will remain on a glass surface. If the lamp is used, the oil can cause uneven heat dissipation from the surface of the glass and fatigue. Touching the lamp during installation, you can actually cause the bulb to explode.
You also need to clean the projector. MoreProjectors have been circulating the air filter at the sampling point for fresh air through the fan. If not properly maintained, these filters with dust and dirt clogged, obstructed airflow. If you do not have the air filter, dust and dirt can penetrate the device and also surround the lamp housing and increasing the temperature of the lamp. You need the device by spraying the air in ventilation ducts in a cleanIn order to blow the dust and dirt.
For the final step, you can use the projector when not in use. And 'the best practical way to extend the life of the bulb. Pulling the projector on unnecessary periods of time constitute the entire lamp life.
0 comments:
Post a Comment